All Installations; New Installation - NuTone SENSONIC VOICE VC110CCT Installation Instructions Manual

Remove all packing material, unplug
1 1
and remove blower from fan housing.
Attach damper/duct connector to
1 4
fan housing.
Push connector
through opening
from inside of
housing.
Engage tabs
and secure with
TABS
screw from parts
bag.
Connect 4-in.
1 6
round duct.

ALL INSTALLATIONS

1 2

NEW INSTALLATION

1 5
Make sure bottom of housing will
be fl ush with fi nished ceiling.
For proper location using 1/2"
ceiling material: Bend out housing
tabs (on outside of housing) to fi t
against bottom of joist.
Secure housing through mounting
ears with appropriate fasteners. If
mounting housing to I-joist, use
wood blocking as shown.
Connect wiring.
7
1
Connect power cable
that will supply constant
120V AC to unit. Attach
wiring to wiring plate
(from parts bag) using
UL approved connector.
Connect house wiring to
fan wiring - black to black,
white to white, and green
to green or bare wire. Use
screw (from parts bag)
to secure wiring plate to fan housing. Re-install
wiring panel and secure with screw from parts bag.
See wiring diagram on page 4.
Remove wiring panel
from fan housing (if
already installed).
Mount housing to ceiling structure.
2
A pair of fl anges
1 3
may be attached to
housing if desired or
required.
Snap both fl ange pieces under
rolled-over edge of housing (all four
sides).
For Retrofi t Installation -
Skip to Page 3.
HOUSING TABS
Finish ceiling.
1 8
Then continue with Step 9.
I-JOIST
WOOD
BLOCKING