Sanyo PLC-XU116 Service Manual page 15

Mechanical Disassembly
2. Main Board, AV Board, Rear Panel and Fans removal
1. Remove screw A (M2.5x6) to remove the Lamp top shield.
2. Remove 6 screws B(M2.5x6) to remove the Main board.
3. Release 4 hooks to remove the Rear panel and remove 2 screws
C(T3x6) to remove the Rear panel and AV board.
4. Remove 2 screws D(T3x6) to remove fans (FN901, FN902).
Main board
B (M2.5x6)x6
AV board
Lamp top shield
3. Fan (FN903) removal
1. Remove screw A(M3x8) to disconnect
the lamp ballast socket.
2. Remove screw B(T3x8) to remove
fan (FN903).
B
C (T3x6)x2
B
C
B
B
A (M2.5x6)
D
B (T3x8)
Trigger
Ballast
A (M3x8)
socket
Fig.3
-15-
Rear panel
Hooks
B
D (T3x6)x2
FN902
FN903
Trigger
* Trigger should be mounted as the
figure above.
FN901
Side grill
Fig.2
Duct