Superior DRT35STDMN Installation And Operation Instructions Manual page 62

Innovative Hearth Products
Superior DRT35 See Through and Peninsula Direct Vent Gas Fireplace
TM
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY
A. When lighting the appliance, follow these instructions
exactly.
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal
B. BEFORE OPERATING smell all around the appliance area
injury or loss of life.
for gas. Be sure to smell next to the floor because some
gas is heavier than air and will settle on the floor.
A. This appliance has a pilot which must be lighted by a piezo igniter. When
lighting the pilot, follow these instructions exactly.
WHAT TO DO IF YOU SMELL GAS
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to
smell next to the floor because some gas is heavier than air and will settle
• Extinguish any open flame.
on the floor.
• Open windows.
WHAT TO DO IF YOU SMELL GAS:
• Do not light any appliance.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building. • Do not touch any electrical switches.
• Do not use any phone in your building.
1. STOP! Read the safety information above on this label.
2. (If applicable) Set the thermostat to lowest setting. Turn wall on/off
1. STOP! Read the safety information above on this page.
switch, unit mounted on/off switch or remote control switch "OFF."
3. Turn OFF all electric power to the appliance.
2. Turn remote wall switch to "OFF."
4. Access the control compartment.
5. Push in gas control knob slightly and turn clockwise
3. Open lower control compartment door.
NOTE: Knob cannot be turned from "PILOT" to "OFF" unless knob is
pushed in slightly. Do Not force.
4. Verify main line shut-off valve is open.
6. Wait five (5) minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP! Follow "B" in the
safety information above on this label. If you don't smell gas, go to the
next step.
7. Find pilot - located in firebox on the same plane as the top of the burner.
8. Turn knob on gas control counterclockwise
9. Push in control knob all the way and hold in. Immediately light the pilot
by triggering the piezo igniter (pushing the button) until pilot lights.
Continue to hold the control knob in for about 1-1/2 minutes after the
pilot is lit. Release knob and it will pop back up. Pilot should remain
lit. If it goes out, repeat steps 5 through 9.
• If knob does not pop up when released, stop and immediately call
your service technician or gas supplier.
1. For complete shut-down, turn remote wall switch to
1. (If applicable) Set the thermostat to lowest setting. Turn wall on/off
"OFF."
switch, unit mounted on/off switch or remote control switch "OFF."
Turn OFF all electric power to the appliance, if service is to be
2.
performed.
2. Open lower control compartment door.
3. Access the control compartment.
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with this
62
appliance and shall be installed for the protection of children and other at-risk individuals.
P/N 900327-00 Rev. 0
LIGHTING INSTRUCTIONS - ELECTRONIC
FOR YOUR SAFETY READ BEFORE LIGHTING
RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
FOR YOUR SAFETY READ BEFORE LIGHTING
LIGHTING INSTRUCTIONS
LIGHTING INSTRUCTIONS
to "OFF."
to "PILOT."
TO TURN OFF GAS TO APPLIANCE
TO TURN OFF GAS TO APPLIANCE
DANGER
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
• Immediately call your gas supplier from a neighbor's
phone.
• If your gas supplier cannot be reached, call the fire
department.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas
C. Use only your hand to turn the gas control lever. Never
supplier's instructions.
use tools. If the lever will not turn by hand, do not try
• If you cannot reach your gas supplier, call the fire department.
to repair it, call a qualified service technician. Force or
C. Use only your hand to push in or turn the gas control knob. Never use tools.
attempted repair may result in a fire or an explosion.
If the knob will not push in or turn by hand, don't try to repair it, call a
qualified service technician. Force or attempted repair may result in a fire or
D. Do not use this appliance if any part has been under
explosion.
water. Immediately call a qualified service technician
D. Do not use this appliance if any part has been under water. Immediately call
to inspect the appliance and to replace any part of the
a qualified service technician to inspect the appliance and to replace any
control system and any gas control which has been under
part of the control system and any gas control which has been under water.
water.
• If the pilot will not stay lit after several tries, turn the gas control
knob to "OFF" and call your service technician or gas supplier.
5. Turn the ON/OFF switch to "OFF". Do not force.
10. Turn gas control knob counterclockwise
11. Close control compartment.
6. Wait five (5) minutes to clear out any gas. If you then
12. (If applicable) Turn on all electrical power to the appliance.
smell gas, STOP! Follow "B" in the safety information
13. (If applicable) Set thermostat to desired setting. Turn wall on/off switch,
above on this page. If you do not smell gas, go to the
unit mounted on/off switch or remote control switch "ON."
next step.
Gas Control Valves
7. Turn the ON/OFF switch to "ON". Do not force.
SIT
8. Turn "ON" all electrical power to appliance (remote wall
switch).
IN OUT
Gas Control Knobs
9. Close lower control compartment door.
Robertshaw
TO SHUT OFF
PILOT
1. Turn off all electrical power to the appliance (remote wall
Honeywell
switch).
3. Turn the ON/OFF switch to "OFF". Do not force.
Push in gas control knob slightly and turn clockwise
4.
Do not force.
5. Close the main line gas shut-off valve.
4. Close the main line shut-off valve.
6. Close control compartment.
5. Close lower control compartment door.
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Installation and Operation Instructions
900300-00, 02/2015
to "ON."
Pilot Assemblies
to "OFF."
9-5/8"