Superior DRT35STDMN Installation And Operation Instructions Manual page 43

Innovative Hearth Products
Superior DRT35 See Through and Peninsula Direct Vent Gas Fireplace
TM
b. Install the burner as shown in Figure 72.
Ensure that the arm of the venturi of the burner
is hooked onto the air shutter adjustment lever
(refer to Figure 66 on Page 42). The primary air
opening can be adjusted by rotating the adjust-
ment lever from beneath the firebox floor. Refer
to Figure 64 on Page 37 for the recommended
minimum primary air shutter opening setting.
Burner Orifice Sizes (all models)
Natural
Elevation
Gas
Feet (meters)
drill size (inches) drill size (inches)
0 - 4500 #37 *
(0-1372) (.104")
* Standard size installed at factory
Table 11
Figure 71
BURNER POSITIONING
Propane
Gas
1.55
mm *
(.061")
Pan Burner
Figure 72
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Step 9. Reassemble the remaining components
by reversing the procedures outlined in the
preceding steps.
Use pipe joint compound or Teflon tape on all
pipe fittings before installing (ensure propane
resistant compounds are used in propane ap-
plications, do not use pipe joint compounds
Pilot Assembly
on flare fittings).
Step 10. Attach the conversion label provided
in the conversion kit to the rating plate on the
appliance.
Step 11. Turn on gas supply and test for gas
leaks.
Valve Access Side
NOTE: Front Face Assembly with
barrier installed must be reinstalled
prior to operation.
Installation and Operation Instructions
900300-00, 02/2015
43