Remote Control - C.E.C. CD5300 Owner's Manual

Remote Control

• Avoid exposure of the remote sensor to direct sunlight or other light sources as such exposure can
cause malfunction.
• When operating the remote control unit, pay attention to a free way to the CD5300, otherwise
control may not be possible.
• When operating the remote control unit, point the unit's infrared signal transmitter at the remote
control receiver behind the window on the front panel of the CD5300.
• When the batteries are exhausted, the remote commander will not operate the unit. In this case,
replace the batteries with new ones. Use only batteries of same type.
If you should have any further question or problem concerning your unit, please contact your CEC dealer.
The included remote control is for the use with CEC CD transport, CD player, digital to analog
converter and amplifier. This manual just describes the functions concerning the CD5300.
MEMO, CHECK and CLEAR for programmed playback,
TIME to show 1. elapsed time of the actual track
Press the numeric button corresponding the required track. The
Example to play track 28: Press +10 > +10 > 8.
SHUFFLE: This function plays the tracks of a CD randomly.
INTRO: Plays the beginning of each track for 10 seconds.
1/ALL: To repeat a CD press 1/ALL once, for a track twice.
*) REPEAT A-B:
1. Press PLAY to start playback
2. Designate the point where the repeat play-back should
start (point A) by pressing A-B - The Repeat and A indi-
cators light
3. Press A-B again at the ending point
The portion will be played repeatedly until pressing A-B
again to terminate the function.
2. remaining time of the actual track
3. remaining time of the whole CD
1...9; +10; 0
player starts from the specified track directly.
SEARCH: High speed music search.
SKIP: Jump to next or previous track.
A-B: To repeat a designated section *).
DITHER, FILTER,
see Front Panel Functions.
see next page.
- Direct access play.
PLAY / PAUSE
STOP
-FS:
D/A Converter options,