How To Switch Camera Mounts - YUNEEC GB200 Quick Start Manual

Step 4: Spin the gimbal motor shaft until the ' at spot' is facing
the setscrew hole. Insert and tighten the setscrew to secure the
GoPro® mount to the GB200™.
HOW TO SWITCH CAMERA MOUNTS: GoPro3/3+® to CGO1™ (B)
Step 1: Rotate the GoPro® camera mount - as shown in illustration
B - until the at spot inside the setscrew hole is facing up, and
loosen the setscrew using the hex wrench.
Step 2: Carefully remove the GoPro® camera mount by sliding it
outward away from the gimbal motor and remove the gyro board
from the gyro board mount.
Step 3: Insert gyro board into the gyro board mount on the CGO1™
camera mount, and wrap the gyro board wire harness clockwise
one whole turn around the end of the camera mount toward the
gimbal motor.
Step 4: Spin the gimbal motor shaft until the ' at spot' is facing
the setscrew hole. Insert and tighten the setscrew to secure the
CGO1™ mount to the GB200™.
7