YUNEEC GB200 Quick Start Manual page 15

Gimbal will not
power on.
Gimbal does not
respond to control
inputs and LEDs
are glowing solid
RED and BLUE.
Red LED on gimbal
ashes slowly and
gimbal is
inoperable.
Gimbal control
harness may not be
connected into the
correct port.
Gimbal may not have
positive connection
via control harness or
satellite receiver.
The gyro board
harness may have
disconnected from
the GB200™ control
board.
15
If using GB200™ with
Blade® 350 QX2, be sure
to connect the control
harness to the camera
pitch control port . If
using with any other
model, be sure to
connect PWM input
to port the universal
PWM input port and
mode control port
Check gimbal control
harness/satellite r
eceiver for a solid
connection. Try
disconnecting and
reconnecting the
control harness/satellite
receiver and cycling the
power on/o .
Check the connection
between the gyro
board and the GB200™
control board.