How To Fold, Move And Release The Treadmill - Branx Fitness CARDIO PRO 4400 User Manual

HOW TO FOLD, MOVE & RELEASE THE TREADMILL
HOW TO FOLD THE TREADMILL FOR STORAGE
Unplug the power cord. CAUTION: You must be able to safely lift 25 kg (55 lbs.) in order to
raise, lower, or move the treadmill.
1. Hold the treadmill with your hands in the locations shown directly below.
CAUTION:
your legs and keep your back straight. As you raise the treadmill, make
sure to lift with your legs rather than your back.
running deck is locked into position. You will hear a "Click" sound as the locking wheel pin
engages with the slot in the sliding locking bar.
2. Gently tighten the locking wheel pin. Your treadmill has now been safely folded.
To protect the floor or carpet from damage, place a mat under the treadmill. Keep the
treadmill out of direct sunlight. Do not leave the treadmill in the storage position in
temperatures above 30° C (85° F).
HOW TO MOVE THE TREADMILL
Before moving the treadmill, convert the treadmill to the storage position as described above.
Make sure that you have gently tightened the locking wheel pin and gently test before
moving that the treadmill looks and feels safe enough for you to move it.
1. Ensure that the area in which your treadmill will be moving to is clear, clean and flat.
2. Tilt the treadmill forward until it rolls freely on its wheels. It is recommended that the
treadmill is moved by 2 persons at all times. To reduce the risk of injury , use
extreme caution whilst moving the treadmill. Do not attempt to move the treadmill
over an uneven surface.
3. Place one foot on the base, and carefully lower the treadmill until it is resting in the
To decrease the possibility of injury, bend
Raise the treadmill fully until the
Page 32 www.branxfitness-helpdesk.co.uk
storage position.
4. Your treadmill should now be in its desired location.
Please always take caution if moving the treadmill upstairs or to a new property or out building etc.
For such moves it is always recommended to instruct a qualified engineer from Branx Fitness (at a
cost) or to disassemble the treadmill safely to assume the flat packed position and refit assembly
brackets and screws etc before attempting to lift, as recommended in the set up instructions
section. The treadmill should also be secured into the original packaging for significant moves to
ensure no damage comes to the treadmill.
HOW TO LOWER (RELEASE) THE TREADMILL FOR USE
1. Ensure that the area in which your treadmill running deck will occupy in its unfolded state
is clear, clean and flat.
2. Hold the treadmill firmly with both hands, and lower the treadmill to the floor.
CAUTION:
your legs and keep your back straight.
3. Push gently against the fixed running deck in the direction of the console to remove the
load from the locking wheel pin. Then pull the locking wheel pin (twist if required to enable
its release) to disengage from the sliding bar.
4. On the release, the treadmill running deck hydraulic strut will take care of the rest,
ensuring a safe, smooth, quiet and controlled decent of the running deck without any
guidance required from the user.
5. The treadmill should now be ready to use.
To decrease the possibility of injury, bend
Page 33 www.branxfitness-helpdesk.co.uk