Id-Address; Edit Custom; Setting - Varytec LED ROAD PAR 14 x 3W RGB 3in1 User Manual

4.2.6 ID-address

Enter the [Id] mode to set the ID-address of the device.

4.2.7 Edit Custom

Here you can change the programs [PR.01] to [PR.10.
Each custom program has 30 steps that can be edited.
Each step allows creation of a scene using: Red, Green, Blue, White, Strobe, Time, and Fade.
Press ENTER for 5 seconds to store your settings.

4.2.8 Setting

Select [UPLD] to upload the custom programs from the current Master unit to the Slave units. In order
to activate the upload function the password must be entered: ([UP] + [DOWN] + [UP] + [DOWN])
Confirm with ENTER.
When uploading the Slave units will display yellow. If an error occurs when uploading the Slave units
will display red. On successful uploading of the custom programs the Slave units will display green. In
order to reset custom modes to default values select [REST].
Enter [ID] in order to allow/disallow ID address function from DMX512 controller.
If you choose in [RGBW] mode the option [YES], an internal white balance is adjusted to get a
harmonious white. If you choose [NO] all colors are driven with 100%.
The RGBW parameters can be set in [CAL2] menu.
Enter [POW] to set the power consumption. The power consumption is 25W if you choose [NORM]-
mode and 50W in [HIGH]-mode.
Enter [DIM] mode to select dimmer mode and dimmer speed. When dimmer mode is set to [OFF] the
behavior of dimming is linear. Dim 1, 2, 3, 4 are dimmer with different speed, dim 4 is the slowest. The
settings in [DIM] mode do not react to the [STAG] mode.
8 / 13