Using The Vacuum - Shark NVC80C Owner's Manual

Using the Vacuum

IMPORTANT: To protect your
carpets, the brushroll will only
turn on when you have pulled
the handle back towards you and
released the Floor Power Nozzle.
3 Power Switch
Settings
OFF
Bare Floors /
Tools
Carpets
Your Shark Navigator
®
Professional Vacuum can be used to
clean bare floors or carpets – with the
click of a switch.
Stand the vacuum into the upright
position.
Plug in the vacuum.
1
Start with the Power Switch in the
"O" - Off position.
2 Place your foot on the Floor Power
Nozzle and pull handle towards
you.
3
Set the Power Switch to desired
cleaning setting.
4
Push the power cord into the
groove on the handle and then
secure the power cord into the
cord clip.
6 TOLL FREE: 1-800-798-7398
NVC80C_26_IB_E_F_111130_4.indd 6
4
5 Press the On/Off switch to the"I"
™
position to vacuum bare floors or
cleaning with the hose (straight
suction only) or to the "II"
position to engage the motorized
floor brush (for vacuuming carpets
and rugs).
6 Due to the huge suction
power of this vacuum, it may
become necessary to adjust
the suction release on the
hose. If the vacuum is difficult
to push or pull or if it is
lifting up area rugs, adjust the
suction release by opening
the valve at the top end of
the hose. Close the suction
release valve for maximum
suction when vacuuming
floors or when using the pet
hair power brush.
2
Release suction for
easier push and pull
on high pile carpets
and area rugs.
Suction Release
IMPORTANT:
Your Brushroll Indicator Light
will illuminate solid green when
the brushroll is on, or solid red if
there is a blockage. This feature is
designed to protect your Lifetime
Belt that powers your brushroll.
See Checking for Blockages
on page 11.
NOTE: The height of your power
nozzle has been optimized
for easy pushing and superior
cleaning on all floor types, so there
is no need to make any height
adjustments as you transition to
different floor & carpet types.
11-11-30 10:00 AM
6