Dell PowerVault MD3200i Hardware Installation And Troubleshooting Manual page 40

storage array has a single controller (simplex) or dual controllers
(duplex) and whether to use IPv4 or IPv6 protocol to communicate
with the management port of the storage array.
The next screen displays a list of the iSCSI-based MD storage arrays that were
discovered based on the discovery process selected in step 3. If you select
Automatic Discovery, the screen displays a list of iSCSI-based MD storage
arrays that were discovered in the subnet. If you select Manual Discovery, the
list contains only the array whose IP address was entered. To add additional
arrays to the list, click on the Add button on this screen.
7 Select the array by clicking the radio button of the corresponding storage
array and then click Next.
8 Enter the name of the storage array and the password.
9 Click the Set Password check-box if you want to set a new password for the
array and enter the new password in the New Password and Confirm New
Password fields. Click Next to continue.
10 Select the IP protocol (IPv4/IPv6) that the management ports must use.
Also for each protocol, select whether the configuration of the
management port IP addresses requires to be done manually or
automatically. See the online help for more details.
11 Click Next to continue. If you have not selected the Specify
Configuration Manually option for any of the two protocols, go to step 13.
12 If you have selected Specify Configuration Manually for any of the two
protocols in the last step, a series of screens showing the backend view
image of the storage array controllers are displayed. Each image contains
IP addresses of management ports of the controllers. Also, each image has
a management port highlighted in red.
• For IPv4 address of the highlighted port, enter the IP address, subnet
mask and gateway address in the fields below the image to modify it.
• For IPv6 address of the highlighted port, enter the local IP address,
routable IP, and router IP address in the fields below the image to
modify it.
Click Next to continue through these images to complete the
configuration of all the management ports for the selected protocols.
40
Preparing Your Systems for Clustering