Install The Ductwork; Prepare The Hood; Measure The Installation - Broan B5330SS Installation Instructions Manual

INSTALL THE DUCTWORK

(Ducted Hoods Only)
1. Decide where
the ductwork
will run
between the
hood and the
outside.
2. A straight, short
duct run will
allow the hood
to perform most
efficiently.
3. Long duct
runs, elbows
and transitions
ABOVE COOKING SURFACE
will reduce the
performance of
the hood. Use as few of them as possible. Larger ducting
may be required for best performance with longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.

MEASURE THE INSTALLATION

6" ROUND DUCT
DECORATIVE FLUE
ROUND ELBOW
HOOD
3-5/32"
30" TO 36" ABOVE
COOKING SURFACE
A maximum of 36" above cooktop is recommended for best
capture of cooking impurities. The bottom of the hood MUST
NOT BE LESS than 30" above the cooktop.
Distances over 36" are at the installer and users discretion;
providing that the ceiling height permits.
ROOF CAP
6"
ROUND DUCT
DECORATIVE
WALL CAP
FLUE
ROUND
ELBOW
HOOD
3¼" FROM
WALL TO
DUCT
CENTERLINE
30" TO 36"
ROOF CAP
WALL CAP
HOOD
MOUNTING
BRACKET
13-9/16"
TO CENTER OF
BRACKET HOLES
MODELS B5330SS • B5336SS

PREPARE THE HOOD

Unpack hood and check contents. You should receive:
1 - Hood
1 - Decorative Flue Assembly
1 - Damper / Duct Connector
1 - Lower Flue Mounting Bracket
1 - Upper Flue Mounting Bracket
1 - Hood Mounting Bracket
2 - Aluminum Grease Filters (installed in hood)
1 - Parts Bag containing:
8 - Mounting Screws (#8 x 3/8" Pan Head)
5 - Mounting Screws (#8 x 1-1/2" Flat Head)
2 - Mounting Screws (#8 x 1-3/16" Pan Head)
5 - Drywall Anchors
2 - Washers
1 - Installation Manual
2 WASHERS
5 MOUNTING
SCREWS
(#8 X 1-1/2"
Flat Head)
DECORATIVE FLUE
FLUE MOUNTING
BRACKET
DAMPER / DUCT
CONNECTOR
FLUE MOUNTING
HOOD MOUNTING
BRACKET
8 MOUNTING
SCREWS (#8 x
3/8" Pan Head)
2 MOUNTING
SCREWS
(#8 X 1-3/16"
Pan Head)
UPPER
LOWER
5 DRYWALL
BRACKET
ANCHORS
Page 3