Page 1
INTENDED FOR DOMESTIC COOKING ONLY READ AND SAVE THESE INSTRUCTIONS INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER. HOMEOWNER: USE AND CARE INFORMATION ON PAGES 10 AND 11. Broan-NuTone Canada Inc.; Mississauga, Ontario www.broan.ca 877-896-1119 www.broan.ca REGISTER YOUR PRODUCT ON LINE AT: www.broan.com/register SV08969 rev. B...
(i.e. Crêpes Suzette, Cherries Jubilee, Peppercorn Beef Flambé). To reduce the risk of fire and electrical shock, the Broan power pack models BC2130SS and BC4130SS Clean ventilating fans frequently. Grease should not must be installed only with their own built-in blower(s).
Page 3
- BC2130SS & BC4130SS POWER PACK SYSTEM - TANDARD TANDARD 3¼” 10” W 3¼” 10” R NOT INCLUDED NOT INCLUDED TANDARD 3¼” 10” D NOT INCLUDED 3¼” 10” DAPTER AND AMPER INCLUDED BC4130SS BC2130SS POWER PACK POWER PACK HL0133 - 3 -...
1. PREPARE THE INSTALLATION WARNING When performing installation, servicing or cleaning the unit, it is recommended to wear safety glasses and gloves. Make sure that the following items are included: - Power Pack - Accessories: • 1 Filter • 3¼” x 10” adapter and damper •...
Failure to do so may cause personal injury or damage to countertop or cooktop. TOP VIEW The custom hood must be constructed to fit the shape and total weight of the BC2130SS or BC4130SS power pack models. See chart and illustration for details. OWER OTAL 5/16”...
Page 6
6. REMOVE THE ADAPTER/DAMPER Using a Phillips no. 2 screwdriver, remove both screws retaining the adapter/damper (A) to the power pack inner panel. Set aside the adapter/damper. NOTE: Though picture beside shows a double blower model, this applies also for single blower model.
10. REMOVE THE ELECTRICAL KNOCK-OUT INGLE LOWER INGLE LOWER LOWER Punch out the electrical knockout hole on back (A) OR on top (B), right side of the power pack. Install the wire clamp (included in parts bag). LOWER Punch out the electrical knockout hole on top (B) OR in front (C) of the power pack.
13. CONNECT WIRING WARNING Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with all applicable codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting means to prevent power from being switched on accidentally. Position the power pack below the installed custom hood.
Page 9
15. INSTALL THE ADAPTER/DAMPER ON BACK OF POWER PACK (HORIZONTAL DISCHARGE INSTALLATION ONLY) From the outside of the wall, using two (2) no. 8 x 3/8’’ screws provided in parts bag, secure the adapter/damper to the back of the power pack. Remove tape from damper flap.
18. REINSTALL FILTER CAUTION Remove protective plastic film covering filter before installing it. Rest rear filter edge on filter springs (A) in the power pack. Using the finger cup, tilt up the filter into position. Make sure filter tabs (B) are securely engaged in power pack front edge after installation.
EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OR MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. During this one-year period, Broan-NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.