Pairing The Rs507 Hands-Free Imager Bluetooth Hid; Datawedge - Symbol TC70 User Manual

Figure 73: Pick List Mode with Multiple Bar Codes in Aiming Pattern
4 The captured data appears in the text field.

Pairing the RS507 Hands-Free Imager Bluetooth HID

An RS507 Hands-free Imager can be used with the device to capture bar code data.
Procedure:
1 Ensure that Bluetooth is enabled on both devices.
2 Ensure that the Bluetooth device to discover is in discoverable mode.
3 Ensure that the two devices are within 10 meters (32.8 feet) of one another.
4 Place the RS507 in Human Interface Device (HID) mode. If the RS507 is already in HID mode, skip to step 5.
a Remove the battery from the RS507.
b Press and hold the Restore key.
c Install the battery onto the RS507.
d Keep holding the Restore key for about five seconds until a chirp is heard and the Scan LEDs flash green.
e Scan the bar code below to place the RS507 in HID mode.
Figure 74: RS507 Bluetooth HID Bar Code
5 Remove the battery from the RS507.
6 Re-install the battery into the RS507.
7 On the TC70, touch
8
Touch .
9 Touch
Bluetooth.
10 Touch SCAN FOR DEVICES. The device begins searching for discoverable Bluetooth devices in the area and
displays them under AVAILABLE DEVICES.
11 Scroll through the list and select RS507.
The device connects to the RS507 and Connected appears below the device name. The Bluetooth device is added
to the Bluetooth devices list and a trusted ("paired") connection is established.

DataWedge

DataWedge is a utility that adds advanced bar code scanning capability to any application without writing code. It
runs in the background and handles the interface to built-in bar code scanners. The captured bar code data is
converted to keystrokes and sent to the target application as if it was typed on the keypad.
.
Data Capture | 85
MN001120A01-A | October 2014