Illuminated Entry - Lincoln 2011 Town Car Owner's Manual

Locks and Security
Note: Ensure the brake pedal is not
3
pressed during this sequence.
To reprogram the remote entry
2
transmitters:
4
1. Ensure the vehicle is
electronically unlocked.
2. Put the key in the ignition.
1
3. Cycle eight times rapidly (within
10 seconds) between the 1 (off)
position and the 3 (on) position. Note: The eighth turn must end in the
3 (on) position.
4. The doors will lock, then unlock, to confirm that the programming
mode has been activated.
5. Within 20 seconds press any button on the remote entry transmitter.
Note: If more than 20 seconds have passed you will need to start the
procedure over again.
6. The doors will lock, then unlock, to confirm that this remote entry
transmitter has been programmed.
7. Repeat Step 5 to program each additional remote entry transmitter.
8. Turn the ignition to the 1 (off) position after you have finished
programming all of the remote entry transmitters. Note: After
20 seconds, you will automatically exit the programming mode.
9. The doors will lock, then unlock, to confirm that the programming
mode has been exited.

Illuminated entry

The interior lamps illuminate when the remote entry system is used to
unlock the door(s) or sound the personal alarm.
The illuminated entry system will turn off the interior lights if:
• the ignition switch is turned to the on or the accessory position, or
• the remote transmitter lock control is pressed, or
• after 25 seconds of illumination.
The dimmer panel control must not be set to the off position for the
illuminated entry system to operate.
The inside lights will not turn off if:
• they have been turned on with the dimmer control, or
81
2011 Town Car (tow)
Owners Guide, 1st Printing
USA (fus)