Diagnosing Problems; Troubleshooting; Error Messages - IBM ThinkPad X40 Series Service And Troubleshooting Manual

Hide thumbs Also See for ThinkPad X40 Series:
Table of Contents

Advertisement

Solving computer problems

Diagnosing problems

If you have a problem with your computer, you can test it by using
PC-Doctor for Windows. To run PC-Doctor for Windows, do as follows:
1. Click Start.
2. Move the pointer to All Programs (in Windows other than Windows XP,
Programs) and then to PC-Doctor
3. Click PC-Doctor.
4. Choose one of the tests, from either Device Categories or Test Scripts.
Attention
Running any tests may take up to several minutes or longer. Make sure
you have time to run the entire test; do not interrupt the test while it is
running.
The System Test of the Test Scripts runs some tests of critical hardware
components, but it does not run all of the diagnostic tests in PC-Doctor for
Windows. If PC-Doctor for Windows reports that all of the tests in the System
Test have been run and that it has found no problems, consider running more
of the tests in PC-Doctor for Windows.
If you are preparing to contact IBM for support, be sure to print the test log
so that you can rapidly provide information to the help technician.

Troubleshooting

If you do not find your problem here, refer to your on-board help system,
Access IBM. To open Access IBM, press the Access IBM button. The following
section only describes problems that might prevent you from accessing the
help system.

Error messages

Notes:
1. In the charts, x can be any character.
2. The version of PC-Doctor referred to here is PC-Doctor for Windows.
Message
0175: Bad CRC1, stop
POST task
0176: System Security -
The System has been
tampered with.
10
®
ThinkPad
X40 Series Service and Troubleshooting Guide
Solution
The EEPROM checksum is not correct (block #6). Have the computer
serviced.
This message is displayed if you remove the Security Chip and reinstall it,
or install a new one. To clear the error, enter the IBM BIOS Setup Utility,
press F9 to set values to default, then press F10 to save changes. If this does
not solve the problem, have the computer serviced.
®
for Windows.

Advertisement

Table of Contents
loading

Table of Contents