Cli Commands Described In This Section; Viewing The Switch's Current Authentication Configuration - HP procurve switch 2600 series Access Security Manual

This example shows the default authentication configuration.
Figure 3-2. Example Listing of the Switch's Authentication Configuration

CLI Commands Described in this Section

Command
show authentication
show tacacs
aaa authentication
console­
Telnet­
num-attempts <1-10 >­
tacacs-server
host < ip-addr >
key
timeout < 1-255 >
Viewing the Switch's Current Authentication
Configuration
This command lists the number of login attempts the switch allows in a single
login session, and the primary/secondary access methods configured for each
type of access.
Syntax:
show authentication
Page
3-9
3-10
pages 3-11 through 3-14
pages 3-15 ­
pages 3-15 ­
3-19­
3-20­
Configuration for login and enable access
to the switch through the switch console
port.
Configuration for login and enable access
to the switch through Telnet.
TACACS+ Authentication
Configuring TACACS+ on the Switch
3-9