Removing And Installing A Device In An Optical Drive Bay - Lenovo ThinkStation P900 User Manual

To reinstall the direct cooling air baffle, do the following:
1. Align the plastic boards on the top and bottom sides of the direct cooling air baffle with the small gaps
1 in the chassis. Ensure that the handle of the direct cooling air baffle faces towards the front of
the chassis.
Figure 32. Aligning the plastic boards with the small gaps
2. Slide the direct cooling air baffle into the chassis until it is secured firmly.
Note: If necessary, adjust the position of the direct cooling air baffle slightly to avoid any interference
with other components in the chassis.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 125.

Removing and installing a device in an optical drive bay

Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page v.
Depending on your computer model, the following devices might be installed in the optical drive bays:
96
ThinkStation P900 User Guide
1