Instructional Procedures For Installation - Boss Infinity Operator, Maintenance And Parts Manual

Instructional Procedures for Installation

of BOSS INFINITY Geared Rotary Screw Air
Compressor
This air compressor should be installed only by those who have been trained and delegated to
do so and who have read and understand both the operators' manual and the installation manual.
Failure to follow the instructions, procedures, and safety precautions in this manual may result in
accidents and injuries.
Install, use, and operate this air compressor only in full compliance with all pertinent O.S.H.A.
requirements and all pertinent Federal, State, and Local codes or requirements and with BOSS
INDUSTRIES, Inc. instructions.
Do not modify this compressor except with written factory approval.
1. MOUNTING COMPRESSOR
When mounting the compressor care should be taken to ensure that its location does not im-
pede the operation of other components on the vehicle. For example, if your vehicle is equipped
with a crane, you must make sure the compressor will not interfere with the swing of the crane.
In addition, the compressor should be installed in an area that permits cool ambient air to enter
the air filter and the hot air from the cooler to exhaust without recirculating into the air filter. One
last consideration in the mounting should be the routing of hoses and electrical wires. The frame
mounting holes are shown below and the unit should be secured to the vehicle with 3/8 inch
grade 8 bolts, washers should be used on the mounting surface. Hardware supplied with unit,
may not work in all applications.
38