Test Mode Specifications In Cd Source; Procedure In Cd-Da Media (Ktd-02A); Audio-Related Test Mode - Kenwood KDC-W4044UA Service Manual

Key
Seek Stop Level
/
adjustment
FM
(Manual)
(UP)
AM
Seek Stop Level
/
(DOWN)
adjustment
(Manual)
Adjustment
■ AUD
value memory
AUD Mode clear
In the band where the local seek can be turned on or off (Local Seek ON/OFF), it is possible to turn on or off the local seek by pressing the [DISP]
key briefl y.
After completing the FST adjustment, if You wish to clear the test mode, You can do this using the reset button.
■ Test mode specifi cations in CD source
Display mode default: P-Time

• Procedure in CD-DA media (KTD-02A)

Key
Track up procedure
Track down procedure
1 Jump procedure
2 Jump procedure
Information display
Name of mechanism type
Mechanism version
Information display
3
Mechanism servo version
(USB)
Information display
Mechanism boot program
version (USB)
5 Jump procedure
6 Jump procedure

■ Audio-related test mode

Procedure
Press the [AUD] key (main unit)
Press the [AUD] and [∗] keys (Remote control)
TEST MODE
Description of display
M N N
M N L
E P W R I
F M 1 9 8 . 3
Description of display
9 B 2 0 :
S E R V :
B O O T :
Enter audio adjustment mode (the initial item should be Fader, and then, Balance →
Bass Level → Middle Level → Treble Level → SW Level → System Q → V-Offset →
LPF Sub Woofer
KDC-W4044UA/W4044UAY/W4044UG/W4044UGY
KDC-W413UA/W413UAY/W4544U/W4644UY
0.00(V) ↔ 5.00 (V) Normal (Local OFF)
V
0.00(V) ↔ 5.00 (V) Normal (Local ON)
V
The display in the left column is shown when the data has
been written in E2PROM by pressing and holding the key for
T E
2 seconds.
To clear FST adjustment (The display returns to the normal
A 4
display but the test mode is retained)
Every time pressed, jumps to the track shown below.
No.9 → No.15 → No.10 → No.11 → No.12 → No.13 →
No.22 → No.14 → No.9 (recursive)
But in case the disc has 8 tracks or less, playback starts with
track No.1. (For both CD-DA and compressed fi le discs)
Goes down by 1 track from the currently played track.
Jump to No. 28 (Scratch 0.7mm for MUSIC line vibration testing)
Jump to No. 14 (Blurring surface disc TCD-731RA Tr14)
Display of name of mechanism type and mechanism version
(Bolero version)
(Press the key while the display is what is shown in the left
column to change to the servo version display.)
Display of mechanism servo table version
(Press the key while the display is what is shown in the left
column to display mechanism boot program version.)
Display of mechanism boot program version
(Press the key while the display is what is shown in the left
column to return to the normal display.)
Jump to No.9 and No.22 (Preset 5 → Track 22 in other track
than Track 22, and Preset 5 → Track 9 in Track 22)
(For linearity check)
Jump to No. 15. Set the volume value to "25".
(For 20Hz 0dB DC protection false-operation FCT checking)
Note
Description
Description
13