Installer: Applicable Controls - Toshiba RAV-CT100-M Installation And Owner's Manual

DX Air Curtain
5
APPLICABLE CONTROLS
REQUIREMENT
• When you use this air conditioner for the first time,
it takes approx. 5 minutes until the remote
controller becomes available after power-on. This
is normal.
<When the power is turned on for the first time
after installation>
It takes approx. 5 minutes until the remote
controller becomes available.
Power
on
flashes
<When the power is turned on for the second
(or later) time>
It takes approx. 1 minute until the remote
controller becomes available.
Power
on
flashes
• Normal settings were made when the unit was
shipped from factory.
Change the indoor unit as required.
• Use the wired remote controller to change the
settings.
• The settings cannot be changed using the wireless
remote controller, sub remote controller, or remote
controller-less system (for central remote controller
only).
Therefore, install the wired remote controller to
change the settings.
Approx. 5 minutes
Remote
controller
goes out
is available
Approx. 1 minutes
Remote
controller
goes out
is available
Changing of settings for

applicable controls
Basic procedure for changing settings
Change the settings while the air conditioner is not
working.
(Be sure to stop the air conditioner before making
settings).
Procedure 1
Push + +
least 4 seconds.
After a while, the display flashes as shown in the
figure.
Confirm that the CODE No. is [10].
• If the CODE No. is not [10] push
erase the display content and repeat the
procedure from the beginning.
(No operation of the remote controller is accepted
for a while after
(While air conditioners are operated under the
group control, "ALL" is displayed first. When
is pushed, the indoor unit number
displayed following "ALL" is the header unit).
(* Display content varies with the
9
buttons simultaneously for at
button to
button is pushed).
indoor unit model).
Installer