Satel SATELLINE-1AS User Manual page 7

GENERAL
Operating Voltage
Current Consumption
Antenna Connector
Size H x W x D
Installation plate
Weight
Temperature Range
SATELLINE-2AS
Satelline-2AS complies with the following international standards:
I-ETS 300 220, CEPT T/R 20-04 (radio standard) and the model m2 also with prETS 300
683 (EMC standard)
TRANSCEIVER
Frequency Range
Channel Spacing
Number of Channels
Frequency Stability
Method of Modulation
Transmitter
Carrier Power
Adjustment range
Carrier Power Stability
Frequency Deviation
Adjacent Channel Power
Spurious Radiations
Receiver
Sensitivity
Co-channel rejection
Adjacent channel selectivity
Intermodulation attenuation
Spurious radiations
MODEM
Interface
Interface Connector
Data Speed
Modulating Signal
Data Formats
Data Squelch
SATELLINE-1AS and SATELLINE-2AS
+ 10...+ 13 Vdc
When DTR is "0":
When DTR is "1":
TNC, 50 ohm, female
137 x 67 x 29 mm
130 x 63 x 1 mm
230 g
- 25 C...+ 55 C
400...470 MHz / base band 2 MHz
25 kHz
16 (selectable by a Hex switch)
< ± 1.5 kHz
FSK
500 mW/ 50 ohm ( + 27 dBm)
20mW... 1 W / 50 ohm (factory set)
+ 1 dB / - 2 dB
± 2.5 kHz
< 200 nW
I-ETSI 300 220
< -108 dBm (BER < 10 E-4)
> 8 dB
> 65 dB
> 65 dB
< 2 nW
RS-232
D15 connector, female
300 - 4800 bit/s
Manchester-coded NRZ
Asynchronous data: 10 or 11 bits
On the modem board: prevents interference
from appearing to the RD line in receiving
mode
7
0.4 mA
Receiving: 55 mA
Transmitting: 330 mA