Advantech OP-20PZ User Manual

Model OP-20PZ 200 Watt Power Supply

Specifications

Input

AC Input voltage range 100-240 V
AC Input frequency
Inrush current

Output

O/P voltage
Min. load current
Max. load current
Line regulation
Load regulation
Cross regulation
Ripple & Noise
Over shoot
Overall Efficiency
Performance Hold up time
Power factor correction PFC can reach the target of 95% @ 115V, full load, following the
Features Over power protection Over power protection at 110%¡ ã 160% of rated output power .The
Over voltage protection If an over voltage fault occurs (internal of the power supply)¡ A the
Short circuit

Environmental

Temperature

Safety standard

Designed to meet
standard

EMI standard

Designed to meet
standard
Unit User's Manual
(with ± 10% tolerance)
AC
60-50 Hz
65/130A @cold start for 110/220 V
+5V +12V
2.0 1.0
16
± 50mV ± 100mV
± 250mV ± 600mV ± 250mV ± 1200mV ± 165mV ± 250mV
± 250mV ± 600mV ± 250mV ± 1200mV ± 165mV ± 250mV
50 120
mVp-p mVp-p
Note: Peak to peak with 20MHz bandwidth
Any overshoot at turn on or turn off shall be less than 15% of the
nominal voltage value.
Typical 65%@115V, full load
When power shutdown DC output 5V must be maintain 16msec in
regulation limit at normal input voltage.
standard of IEC 1000-3-2.
power supply latches all DC output into a shutdown state.
power supply will latch all DC output into a shutdown state before
+5V ¡ G 5.6V ¡ ã
+3.3V ¡ G 3.6V ¡ ã
+12V ¡ G 13.2V ¡ ã
A: A short circuit placed on any DC output to DC return shall cause
no damage.
B: The power supply shall be latched in case any short circuit is taken
place at +5V, +3.3V, +12V output.
C: The power supply shall be auto-recovered in case any short circuit
is taken place at -5V, -12V, +5V
Operating
UL 1950; TUV EN60950; EN 61000-4-2(ESD) Criterion B, ¡ Ó 4KV by
contact, ¡ Ó 8KV by air; EN 61000-4-4(EFT) Criterion B, ¡ Ó 1KV; EN
61000-4-5(SURGE) Criterion B, Line-Line ¡ Ó 1KV, Line-Earth ¡ Ó 2KV.
FCC part15, CISPR 22(EN 55022)
1
(at 25 ¢ J ambient )
AC
-5V -12V
0.1
9 0.2
± 50mV ± 120mV
100
mVp-p mVp-p
6.6V
4.2V
14.6V
SB
0 ~ 40¢ J
+3.3V +5V
0.1 1.0
0.7 14
± 50mV ± 50mV
120 60
mVp-p
SB
0.1
1.5
60
mVp-p