Table of Contents
Advertisement
OBJ_BUCH-2087-002.book Page 2 Wednesday, July 16, 2014 5:12 PM
Display elements of on-board computer
a Drive unit assistance indicator
b Assistance-level indicator
c Light indicator
d Text indication
e Value indication
f Speed indication
g Shift recommendation: higher gear
h Shift recommendation: lower gear
i Battery charge-control indicator
Technical Data
Drive Unit
Article number
Rated continuous output
Torque at drive, max.
Nm
Rated voltage
Operating temperature
Storage temperature
Degree of protection
Weight, approx.
Drive Unit
Article number
Power
Torque at drive, max.
Nm
Rated voltage
Operating temperature
Storage temperature
Degree of protection
Weight, approx.
On-board computer
Article number
Max. charging current,
USB connection
mA
Charging voltage,
USB connection
Operating temperature
Storage temperature
Charging temperature
Degree of protection
Weight, approx.
Bosch eBike system uses FreeRTOS (see www.freertos.org)
Bosch eBike Systems
Bike lights*
Rated voltage
Power output
– Front light
– Rear light
* Not possible via the eBike battery pack in all country-specific versions,
depending on the statutory regulations
Assembly
Inserting and removing the battery pack
For inserting and removing the eBike battery pack in/from the
Drive Unit Cruise
eBike, please read and observe the battery pack operating in-
0 275 007 033
structions.
0 275 007 027
W
250
Inserting and removing the on-board computer
60
(see figure A)
To insert the on-board computer 3, slide it from the front into
V
36
the holder 4.
°C
–5...+40
To remove the on-board computer 3, press the lock latch 15
°C
–10...+50
and slide the on-board computer toward the front out of the
IP 54 (dust and splash
holder 4.
water protected)
Remove the on-board computer when you park the
kg
4
It is possible to secure the on-board computer against remov-
Drive Unit Speed
al in the holder. To do so, remove the holder 4 from the han-
0 275 007 031
dlebars. Put the on-board computer in the holder. Screw the
locking screw 16 (thread M3, 8 mm long) from below into the
W
350
thread provided in the holder. Mount the holder back onto the
60
handlebars.
V
36
°C
–5...+40
Checking the Speed Sensor (see figure B)
°C
–10...+50
The speed sensor 17 and its spoke magnet 18 must be
IP 54 (dust and splash
mounted in such a manner that the spoke magnet, after a turn
water protected)
of the wheel, moves past the speed sensor with a clearance of
at least 5 mm, yet no more than 17 mm.
kg
4
Note: If the distance between speed sensor 17 and spoke
magnet 18 is too small or too large, or if the speed sensor 17
Intuvia
is not properly connected, the speed indication f will fail, and
1 270 020 909
the eBike drive unit will operate in emergency mode.
In this case, loosen the screw of the spoke magnet 18 and fas-
500
ten the spoke magnet to the spoke in such a manner that it runs
past the mark of the speed sensor at the correct clearance. If
V
5
the speed is still not being indicated in the speed indication f
after this, please contact an authorised bicycle dealer.
°C
–5...+40
°C
–10...+50
°C
0...+40
IP 54 (dust and splash
water protected)
kg
0.15
V
W
W
eBike.
English–2
6
8.4
0.6
0 276 001 SPI | (16.7.14)
Hide quick links:
Advertisement
Table of Contents
