Troubleshooting Guide - Curtis DVD1053 Instructions For Use Manual

24.

TROUBLESHOOTING GUIDE

Observation
No power
Front panel light stays on
in standby mode
The remote control does
not work
The DVD player does not
play
No picture
Picture noise / distorted
Picture not full screen
No, poor, or intermittent
sound
Skip / Search function
does not work
Lost or forgotten password
25. TECHNICAL SPECIFICATION
25.1 Rated voltage
Power consumption
Power consumption (standby)
25.2 CD/DVD
Laser
Signal system
Frequency response (audio)
Signal to noise ratio (audio)
Dynamic range (audio)
Harmonic distortion (audio)
25.3 VIDEO
Video output
25.4 GENERAL
Operating conditions
Operating position
26. RECYCLING ELECTRICAL PRODUCTS
You should now recycle your waste electrical goods and in doing so help the environment.
This symbol means an electrical product should not be disposed of with normal household waste. Please
ensure it is taken to a suitable facility for disposal when finished with.
Visit www.recycle-more.co.uk, click on "bank locator" and enter your postcode to find your nearest
recycling site.
We care about our quality and what you think,
If you have any comments, good and bad,
Please call our Careline 0800 636 262
or visit www.sainsburys.co.uk
Your statutory rights are not affected.
Potential cause / solution
Is the power lead connected to the mains socket correctly?
Does the socket that is being used have power?
This is normal. The indicator light stays on in standby mode. To switch off completely, press
the ON/OFF switch.
Are the batteries exhausted?
Have the batteries been correctly fitted?
Are there obstacles in the between the remote and the sensor on the DVD player?
Is the remote too far away from the sensor?
Has the standby button been pressed?
Is there a disc loaded?
Has the disc been loaded upside down?
Is the region code of the disc compatible with the DVD player?
Is the disc type compatible with the DVD player?
Is the DVD rating above the parental level set?
Is the disc dirty or damaged?
Is the TV set switched on?
Has the TV been turned to AV signal?
Are the connection cables correctly fitted and undamaged?
Has a DVD or Picture disc been inserted?
Is the disc dirty or damaged?
Is the disc dirty or damaged?
Is the DVD player connected directly to the TV set?
Does the TV set colour controls need adjusting?
Some picture distortion is normal during rapid advance or reverse
Has the correct TV display been selected for the TV being used? See set up menu - video.
Has the mute button on the TV been pressed?
Is the TV volume control set at minimum?
Has the TV been switched on?
Are the connection cables correctly fitted and undamaged?
Note: there is no sound output during pause / frame advance / slow and search functions
Some discs are programmed so that these functions do not work in certain sections e.g.
during warnings or during display of legal information.
Single chapter discs do not permit the use of skip function
Enter 9922
110-240V~ 50/60Hz
10W
<1W
Semiconductor Laser, Wavelength 650nm
PAL, NTSC, AUTO
20Hz to 20kHz
>60dB (1kHz NOP, 20kHz LPF/A – filter)
>85dB
0.2% (1kHz)
1.0V (p-p), 75 Ohm
Temperature: 5°C to 35°C
Humidity 5% to 90%
Horizontal
Produced in China for
Sainsbury's Supermarkets Ltd,
33 Holborn,
London EC1N 2HT.
12