Connecting Dvd Player - Curtis DVD1053 Instructions For Use Manual

5.3 Remote control - use
To use the remote control unit, insert batteries into the battery compartment of the remote control unit.
Ensure that the POWER
transmitter on the remote control towards the remote control sensor on the DVD player and press the
function button of choice. Allow time for the remote to respond before pressing another button.
Use the remote handset no more than 6m from the remote sensor and at an angle of no greater than 30°.
6.

CONNECTING DVD PLAYER

ALL EQUIPMENT MUST BE TURNED OFF AND DISCONNECTED FROM THE MAINS BEFORE
7. CONFIGURE THE TV
The DVD player is set to UK PAL TV type as standard; if NTSC is required, see section 20 for set up.
7.1 Place the DVD player horizontal on a flat level surface.
7.2 Connect the DVD player to your TV and / or audio system (as shown in the previous diagrams), plug in
and switch on at the mains.
7.3 Insert the batteries into the remote control.
7.4 Press the POWER button on the DVD player to turn on the player (the power indicator at the side of the
button will illuminate) and turn on the TV and amplifier (if connected).
7.5 Select the video mode (AV) for the TV. If there is more than one video channel (AV1, AV2, etc) select the
source that the DVD player is connected to. See the TV instruction manual for tuning instructions if the set
does not automatically tune.
buttons on the TV and DVD player are switched on. Point the infrared
To audio inputs
of the amplifier
AV Cable
(not included)
White Red
Y
Pb/Cb
To S-Video
output
S-Video cable
(not included)
To S-Video
input
CAUTION !
INSTALLATION
Stereo System
Pr/Cr
OR
Television
5
AC 110-240V~
50/60Hz,10W
To SCART output
SCART Cable
( not included)
To SCART
input