Table of Contents
Advertisement
Specification
Compatible disc: DVD+R/RW, DVD-R/RW, CD-DA,
CD-R/RW, JPEG
Signal system: PAL/NTSC
Panel size: 9 inch
Picture resolution: 640x234 (RGB) or 640x220(RGB)
Frequency response: 20 Hz to 20 kHz
Video output: 1 Vp-p/75 Ohm, unbalanced
Audio output: 1.4Vrms/10kOhm
Audio S/N: Better than 80 dB
Dynamic range: Better than 85 dB
Laser: Semiconductor Laser, Wave Length: 650 nm/795 nm
Power source: DC 9-12V
Power consumption: 10 W
Operating temperature: 0 ~40
Weight : 0.99 kg
Dimensions (W x D x H): 234 x 185 x 42 mm
Battery Type: Li Polymer
Note:
1.The quality and speed for reading JPEG photos depend on the resolution and
compression ratio of the photos. Some JPEG photo may not be played due to the
disc quality and the formats.
2.Some DVD+R/RW,DVD-R/RW,CD-R/RW disc may not be played due to the
quality on burning conditions.
Rechargeable battery use
The unit utilizes long-life Li polymer battery for portable power supply. The battery
has no Memory Effect and thus can be recharged safely regardless of whether the
battery is fully or partially discharged. It is enough to recharge no longer than 4H
each time. Fully recharged battery can last about 2.5 hours with earphones on.
Precautions related to Battery Recharge
The battery can be only recharged when turning power to OFF state,and keep
continuous power supply,the red light will be on,and the light will turn yellow when it
is fully charged.
Using and Maintaining Rechargeable Battery
1. The normal working temperature is: 0 ~40 ;
2. Always unplug AC/DC power supply for the unit when not in use;
3. Heat will create during playing, it's normal, while avoid long time playing and
unattended;
4. Avoid having the unit collide with any objects, and place away from all possible
heat sources or damp areas.
Caution: Danger of explosion if battery is incorrectly replaced. Replace only with
the same or equivalent type.
12
Before to discard EOL unit, please remove the waste battery by below steps:
a. Pull out the screws on the bottom cover by the screwdriver to unpack the unit.
b. Pull out the screws on the Main PCB board by the screwdriver to unpack the
PCB board and then the battery can be seen.
c. Remove the battery socket from the board.
Troubleshooting
PROBLEM
Make sure the machine is connected properly.
No sound or
Make sure all cables are securely inserted into
distorted sound
the appropriate jacks.
You can't advance through the opening credits
Can't advance
and warning information that appears at the
through a movie
beginning of movies because the disc is
programmed to prohibit that action.
The feature or action cannot be completed at
this time because:
1. The disc's software restricts it.
The icon
2. The disc's software doesn't support the
appears on
feature (e.g., angles)
screen
3. The feature is not available at the moment.
4. You've requested a title or chapter number
that is out of range.
The disc might be damaged. Try another disc;
Picture is
It is normal for some distortion to appear during
distorted
forward or reverse scan.
Some discs have sections that prohibit rapid
scanning or chapter skip;
No forward or
If you try to skip through the warning information
reverse scan
and credits at the beginning of a movie, you
won't be able to. This part of the movie is often
programmed to prohibit skipping through it.
Main PCB
SOLUTION
13
Advertisement
Table of Contents
