Electrical Faults - C&K systems Securit 703 User Instructions

2.0 UNSETTING
Enter by your usual route, the buzzer will sound, do not stop go
directly to the keypad. Enter the four digit code, the buzzer will stop and the
control return to the 'DAY' mode. If the exit time has less than 10 seconds
remaining the buzzer will emit a quick pulsing sound to indicate "HURRY
UP".
If you get a pulsed entry tone from the sounder then your alarm has activated
and reset itself. See section 3.6.
3.0 FAULTS
3.1 TAMPER FAULTS DURING AN UNSET PERIOD. (DAY MODE)
A tamper fault during the day is indicated by the internal sounder and
the tamper LED. Enter your four digit user code to stop the sounder, the
sounder will now change to a low level two tone alternating sound to indicate
that there is a "RESET REQUIRED". Press the # key to reset the system.

3.2 ELECTRICAL FAULTS .

Faults caused by your standby battery being in a poor condition will
activate the internal sounder and the fault LED. Enter your four digit user
code to stop the sounder, the sounder will now change to a low level two tone
alternating sound to indicate that there is a "RESET REQUIRED". Press the #
key to reset the system.
The green LED at the top left hand side of the keypad display is the Mains
healthy light. If this is not lit and the battery fault light is on then you will not
be able to arm your system. Call your Installer.
3.3 TELEPHONE LINE FAULTS.
If your system is connected to a central monitoring station using a
telephone line connection then the control panel can monitor the phone line.
If the line is faulty then the comms LED will light. (this looks like a phone
handset). The internal sounder may sound, if programmed to do so. Enter
your four digit user code to stop the sounder, the sounder will now change to
a low level two tone alternating sound to indicate that there is a "RESET
REQUIRED". Press the # key to reset the system.
3.4 ALARMS DURING THE SET PERIOD
Enter your four digit user code to unset the system. The LED displa y
will indicate which zone caused the alarm. See section 3.6 to reset the
control.
3.5 PERSONAL ATTACK ALARMS
Enter your four digit user code to stop the sounder. Reset the personal
attack button with the key provided. See section 3.6 to reset the system.
3.6 RESETTING THE SYSTEM
2