C&K systems Securit 703 User Instructions page 2

1.0 SETTING
1.1 FULL SET
To start the exit procedure ensure all alarmed zones are clear and
enter your four digit user code, the buzzer will emit a steady sound and the
exit time will start. Leave the building by the approved exit route and close
the final exit door. Wait outside the door until the buzzer has stopped to
indicate that the panel has armed. If you have a DAY LED this will now be
extinguished. If you need to set the system by using a terminator button or
lock then operate from the outside of the system now.
If any zones are in fault the buzzer will pulse and the LED for that zone
will be lit. Return to the panel and press the "#" key or enter the user code to
abort the exit procedure. Investigate the fault and correct if possible, then
start the exit procedure again. If any zone on the exit route is open (door
open or detector tripped) then the buzzer will pulse on exit but should go to a
clear tone when the zone closes If you are unable to correct the fault contact
your Installer. If you do not complete the exit procedure before the exit time
runs out the internal sounder will start. Enter your user code to stop the
sounder. See section 3.6 to reset the system.
1.2 NIGHT SET. Usually when you go to bed.
Start the exit procedure as for full set as above. Then press the "*" key
followed by the "0" key. The buzzer will change tone and the LED's for any
zones programmed to be isolated in night set will flash. The programmed
Night set exit time will be selected and the exit procedure will continue. If your
system does not allow Night set an error tone will sound and the exit
procedure will be aborted. Again if the panel sets and you have a keypad with
a DAY LED it will extinguish.
1.3 HOME SET. If you want to set during the evening.
Start the exit procedure as for full set as above. Then press the "*" key
followed by the "8" key. The buzzer will change tone and the LED's for any
zones programmed to be isolated in home set will flash. The programmed
night set exit time will be selected and the exit procedure will continue. If your
system does not allow home set an error tone will sound and the exit
procedure will be aborted. Again, if a DAY LED keypad is fitted, once set, the
DAY LED will extinguish.
1.4 MANUAL ISOLATION
Start the chosen exit procedure as above. Then press the "*" key
followed by the zone number you require to isolate. If more than one zone is
required then press the * button followed by the next zone number and so on
until you have completed your choice. If the zone is isolated the LED for the
required zone will flash and the exit procedure will continue. If you hear an
error tone (dah dah) then the required zone may not be programmed for you
to isolate. Contact your Installer.
1