Powering The Camcorder On / Off; Auto Power On/Off; Manual Power On/Off And Reset; Manual Power On - HP f800g User Manual

2.5 Powering the Camcorder On / Off

2.5.1 Auto Power On/Off

Once the vehicle engine is started, the camcorder automatically turns on.
If the Automatic Record function is enabled, the recording will
automatically start right after the camcorder powers on.
Please refer to Set Automatic Record (2.6.1).

2.5.2 Manual Power On/Off and Reset

2.5.2.1

Manual Power On

Slide the power switch and make sure that the power switch locks on the
memory card slot.
2.5.2.2

Power Off

The power switch to the edge and make sure that the memory slot is
released and the camcorder starts power off sequence. Do not power on
the camcorder when it is in the power-off sequence, or the recorded file
may become corrupt.
2.5.2.3

Reset the Camcorder

In case the camcorder fails to function normally due to unknown causes,
slide the power switch and verify the memory card is in the removable
state; wait for 7 seconds and slide the power switch again to restart the
camcorder.
14
On
Off