Sidestand - Yamaha TT-R230B Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
Spring preload:
Minimum (soft):
Distance A = 194 mm (7.6 in)
Standard:
Distance A = 204 mm (8.0 in)
Maximum (hard):
Distance A = 206 mm (8.1 in)
3. Tighten the locknut to the specified
torque. NOTICE: Always tighten
the locknut against the adjust-
4
ing nut, and then tighten the
locknut to the specified torque.
[ECA10121]
Tightening torque:
Locknut:
70 Nm (7.0 m·kgf, 51 ft·lbf)
WARNING
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.
G
Do not tamper with or attempt to
open the cylinder assembly.
G
Do not subject the shock ab-
sorber assembly to an open
flame or other high heat source.
This may cause the unit to ex-
plode due to excessive gas
pressure.
G
Do not deform or damage the
cylinder in any way. Cylinder
damage will result in poor
damping performance.
G Do not dispose of a damaged or
worn-out shock absorber as-
sembly yourself. Take the shock
absorber assembly to a Yamaha
dealer for any service.
EWA10221

Sidestand

1. Sidestand
The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
4-8
WARNING
EAU37490
EWA14190