Operating Instructions - Russell Hobbs RHMF40 Instructions And Warranty

40cm mist fan
Table of Contents

Advertisement

HOW TO ASSEMBLE YOUR MIST FAN
1. Unpack all the parts of the fan and remove all packaging. Dispose of the packaging
safely to avoid accidental suffocation in children.
2. Fix the four castors (10) onto the base (9), and tighten with a small wrench.
3. Insert the motor (7) into the fan body (8) with the adjusting knob (12)
4. Place the fan body (8) onto the base (9) and fasten with the base nut (11).
5. Place the rear guard (6) onto the motor and fasten with the guard mounting nut (5).
6. Place the blade (4) onto the motor shaft, and fasten the blade cap (3).
7. Clip the front guard (2) onto the rear guard (6), making sure that the front mist plate
opening is facing downwards (1).
8. One end of the plastic tube is straightened (13). Place this end into the opening on
the mist plate (1), and push gently until the tube is fixed into place.
9. Place the other end of the plastic tube into the plastic tube entry hole (12) on the
body of the unit (8).
FILLING THE HUMIDIFIER TANK
1. Open the water tank cover using the small flap on the right hand side of the unit.
2. Using the handle on the water tank, lift the water tank in an upward direction, and
pull it out.
3. Tip the water tank upside down and remove the screw cap. Add water to the tank, up
to 1.5 litres. Do not place any liquids in the water tank other than water. Only add
water that is room temperature. Do not use hot water in this unit.
4. Replace the screw cap, and make sure it is fully tightened.
5. Turn the water tank upright and place back into the body of the unit. Ensure that the
water tank sits firmly in the body. Close the water tank cover.
6. Your Russell Hobbs Mist Fan is now ready for use.

OPERATING INSTRUCTIONS

1. Ensure the unit is on a firm, flat surface. Plug the unit into the wall socket and switch
on the wall socket. Use the remote control or the on-board control panel to select the
following:
Speed: Press the On/Speed button to start the unit. Press this button once for
low speed, twice for medium speed and three times for high speed.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents