Table of Contents
Advertisement
Problem
After moving the receiver to
another room/area you are no
longer able to receive digital
reception
The receiver switches off
automatically.
Playback of video (or Timeshift)
is causing picture freeze/macro
blocks or similar distortion,
especially on HD content.
9.0 TEChNICAL SPECIFICATIoNS
Demodulator
Demodulator:
Transmission mode:
video Decoder
Profile level:
Video resolutions:
Decoding & Video out:
Aspect ratio:
Audio Decoder
Audio support:
MPEG MusiCam Layer II
Sampling rate:
Audio mode:
*Dolby and the double-D symbol are registered trademarks of Dolby Laboratories
Tuner
Front End:
Input frequency range:
Loop through frequency range:
Input signal level:
Possible cause
Antenna signals are too weak
The signal strength/quality
might be less than before, if
using an indoor antenna.
Auto Standby function
enabled.
Read/write speed of your USB
device could be too low.
COFDM; 16 QAM/64 QAM, QPSK
2 K - 8 K
MPEG-2 MP@ML, AVC/H264HP@L4.1, MPEG4 ASP supported
480i / 480p / 576i / 576p / 720p / 1080i / 1080p / By Native TV /By
source
PAL
4:3 Letterbox, 4:3 Pan & Scan, 16:9, Auto
AAC/Dolby Digital Plus*/AC3+/PCM
32, 44.1, 48 KHz
Stereo, Mono
DVB-T, UHF & VHF Tuner
174 – 230 MHz (VHF) and 470 - 862 MHz (UHF)
47 - 862 MHz
-20 ~ -84 dBm
What to do
Press the INFo button on
remote 3x to call up signal
bars and adjust antenna for
(maximum) reception
or rescan channels
When using an active antenna,
check antenna power.
Try to use an outdoor antenna.
Disable auto standby. See
section 7.3.7 for details.
Make sure to use a USB storage
device with sufficient speed
and space. Pen drives ('USB
sticks') may not support
sufficient speed.
23
Hide quick links:
Advertisement
Table of Contents
