Table of Contents
Advertisement
Turning the TV on or off
Selecting the input source
Input
TV
AV
SCART
SVideo
COMPONENT
VGA
HDMI1
HDMI2
USB
Move
Enter
Selecting a channel
Adjusting the volume
Displaying program
information
Basic Operations
To turn the TV on or off:
1
Plug the power cord into an AC power outlet.
2
Now the set is in standby mode. Wait some seconds until the power indicator lights
up, then press POWER
pressing POWER button. If you promptly press POWER button then the TV may not
respond or act wrongly.)
3
Press button again to turn off the TV and put the TV in standby mode.
To completely disconnect power, unplug the power cord.
Note: If the TV does not receive a broadcast signal for several minutes, the TV goes into
standby mode.
To select the input source:
1
Press INPUT button.
2
Press 6
or 5
to select the input source, then press ENTER.
You can also select the input source using the following remote control buttons:
HDMI — Press repeatedly to cycle between the HDMI1/HDMI2 mode.
!
COMP — Press to switch to COMPONENT mode.
!
VIDEO — Press repeatedly to cycle between the AV/SCART/SVideo inputs.
!
VGA — Press to switch to VGA mode.
!
TV — Press to switch to TV mode.
!
USB — Press to switch to USB mode.
!
You can use the following ways to change channels:
Press CH+or CH- to go to the next or previous channel. The skipped channels can
!
not be selected.
Press the number buttons to directly select any channel you want, then wait for the
!
channel to change.
Note: Button presses must be within three seconds of each other.
To go to the previous channel viewed, press
!
!
To browse among your favorite channels you setup, press FAVORITE button
repeatedly.
To adjust the volume:
Press the VOL+ or VOL- to increase or decrease the volume.
!
Press the MUTE button to temporarily turn off the sound. To restore the sound, press
!
the MUTE button again.
To display program information:
You can press DISPLAY button to display current program information such as channel
number, color/sound system, or video input source, etc. To clear the display, press this
button again or wait a few seconds and it disappears automatically.
to turn on the TV. (Be sure to wait some seconds before
.
12
Advertisement
Table of Contents
