Table of Contents
Advertisement
First Time Configuration/Basic Operations
The first time you use the TV, you need to configure your TV:
Energy Save Mode
To use this TV for displaying in a store, please select [Store/Dynamic].
[Standard/Energy Save] mode is recommended for normal home use.
Standard/Energy Save
Select
Installation Guide
OSD Language
Country Selection
Channel Tuning
Select
Channel Tuning
ATV
DTV
Radio
2 %... 76.25 MHz
EXIT Exit
Turning the TV on or off
1
Make sure that the power cord is connected to a power outlet.
2
Press POWER
to turn on your TV.
3
Press button again to turn off your TV. Your TV enters standby mode.
Warning: When the TV is in standby mode, power is still flowing into the TV. For the sake of energy saving and safety issue,
please disconnect the power cord to completely cut off the power. After you turn off the TV, you should wait some seconds
before you turn it on again.
Note: If the TV does not receive a broadcast signal for several minutes, the TV goes into standby mode.
Selecting the input source
Input Source
DTV
ATV
AV
Component
D-SUB
HDMI1
HDMI2
USB
Music
Move
Select
Store/Dynamic
OK
OK
English
Australia
Move
EXIT
Exit
:
2 Programme(s)
:
0 Programme(s)
:
0 Programme(s)
(ATV)
MENU Skip
To select the input source:
1
Press INPUT button. The Input Source list appears.
2
Press 6
or 5
to select the input source, then press OK or 4
The TV switches to the selected source.
To configure your TV:
1
Make sure that you have inserted the batteries in the
remote control, have connected your antenna to the
TV, and have connected the AC power.
Press POWER
to turn on the TV. After a few
2
seconds the Energy Save Mode screen opens.
Press 3
or4
to select Standard/Energy Save or
3
Store/Dynamic, press OK to confirm. (For normal
home use, please select Standard/Energy Save.)
Now the Installation Guide screen appears with
4
Country Selection highlighted. Press 3
select Australia or New Zealand.
Press 6
or 5
to highlight Channel Tuning, then
5
press OK to begin the auto tuning for all available
ATV/DTV channels. It may take several minutes,
please wait until it is finished.
During searching, the screen will display a report
about found stations.
When complete, it will go to digital programme
position one. Now channel list has been created and
you can start to watch TV.
or4
to
to confirm your choice.
13
Advertisement
Table of Contents
