Table of Contents
Advertisement
First Time Configuration/Basic Operations
Turning on your TV for the first time
Energy Save Mode
To use this TV for displaying in a store, please select [Store/Dynamic].
[Standard/Energy Save] mode is recommended for normal home use.
Standard/Energy Save
Select
Installation Guide
OSD Language
Country Selection
Channel Tuning
Select
Channel Tuning
ATV
DTV
Radio
2 %... 76.25 MHz
EXIT Exit
Turning the TV on or off
Power Switch
INPUT
Store/Dynamic
OK
OK
English
New Zealand
Move
EXIT
Exit
:
2 Programme(s)
:
0 Programme(s)
:
0 Programme(s)
(ATV)
MENU Skip
To turn the TV on or off:
1
Plug the power cord into an AC power outlet. Press Power Switch on the TV.
2
If no picture appears while the indicator lights up, the set is in standby mode.
Press POWER
to turn on the TV.
3
Press button again to turn off the TV and put the TV in standby mode.
To cut off the power completely, press Power Switch on the TV.
Warning: When the TV is in standby mode, power is still flowing into the TV. For the sake of
energy saving and safety issue, please press Power Switch to completely cut off the power.
After you turn off the TV, you should wait at least 5 seconds (the power indicator goes
out)before you turn it on again.
Note: If the TV does not receive a broadcast signal for several minutes, the TV goes into
standby mode.
The first time you use the TV, you need to configure
your TV:
To configure your TV:
1
Make sure that you have inserted the batteries in the
remote control, have connected your antenna to the
TV, and have connected the AC power.
2
Press the Power Switch on the TV.
3
Press POWER
to turn on the TV. After a few
seconds the Energy Save Mode screen opens.
4
Press 3
or4
to select Standard/Energy Save or
Store/Dynamic, press OK to confirm. (For normal
home use, please select Standard/Energy Save.)
5
Now the Installation Guide screen appears with
Country Selection highlighted. Press 3
select
New Zealand
or
Australia
6
Press 6
or 5
to highlight Channel Tuning, then
press OK to begin the auto tuning for all available
ATV/DTV channels. It may take several minutes,
please wait until it is finished.
During searching, the screen will display a report
about found stations.
When complete, it will go to digital programme
position one. Now channel list has been created and
you can start to watch TV.
or4
to
.
13
Advertisement
Table of Contents
