Samsung 1404262L User Manual page 11

_._ Lack of salt indicator models (*applicable
only)
Turns on when the water softener runs out of salt. (or the dishwasher is
in the standby or pause modes.)
Turns off while the dishwasher is operating.
Delay a cycle for up to 24 hours in one-hour increments. To increase the delay
start time, press or hold the Delay Start button. The hour displayed indicates
the time at which the wash will be started.
After setting the delay time, press the Start button, and then close the
door to start the cycle.
If you want to change the delay time once the dishwasher has started,
press the Reset button and turn off the dishwasher. Then, turn on the
dishwasher again and select a new cycle with a new delay setting.
To start a cycle, press the Start button before closing the door.
..... Reset : To cancel a currently running cycle and drain the dishwasher, press
and hold the Start button for three (3)seconds.
Once the dishwasher is reset, select a cycle and option, and then press Start
to restart the dishwasher.
You can select options (Self Clean, Upper, Lower, Speed Booster, Sanitize, Dry+, Delay Start) before
starting a cycle. If you change the cycle after selecting an option, the original cycle is reset.
_To prevent touchpad losing response sensitivity,
the from follow these instructions:
Touch the center of each keypad using one finger. Do not push.
Clean the touch control's surface regularly with a soft, damp cloth.
Be careful not to touch more than one touch key pad at a time, except as directed.
When you pause a cycle by opening the door during operation, press the Start button before closing
the door to continue the cycle.
English o 11