Table of Contents
Advertisement
Electrical
Warning
Access to the bulbs is gained from the back of the fascia or by removing
the
panel and
centre console.
illumination
lamps
Centre console. Remove the four screws (12) on each side, securing the
centre
Figs. 10 and
11 console. Withdraw the console, tilting the top forward slightly to clear the unde
r
edge of the fascia.
'
Heater control lamp bulb. Remove the push-fit bulb holder
(l)
from the
control
and remove the bayonet fixing type bulb (2).
Instrument panel lamp bulbs. Remove the push-fit bulb holders (3) from
the
instruments and unscrew the bulb (4).
Warning lamp bulbs. Remove the push-fit bulb holders (5) from the lamps an
d
remove the bayonet type fixing bulbs (6). To remove the ignition and
high
beam warning bulbs the centre console must also be withdrawn.
Lights and heater booster switch bulbs. Remove the push-fit bulb holders
(7)
from the switches and remove the bayonet type fixing bulbs (8). To remove
the
lights switch bulb the centre console must also be withdrawn.
Brake failure warning lamp. Remove the retaining spring clip (9) and
withdraw
the holderftest-push assembly from the fascia. Through the two pivot holes
in
the holder depress the pivot legs (10) and remove the test-push rocker from
its
holder. Unscrew and remove the bulb (11).
Fig. 10
4
~~
3
Fig. 11
Hazard switch bulb.
W~thdraw
the centre
console.
Remove the
push-fit
bulb
holder (13) from the
switch,
and remove the bayonet
fixing
type bulbs (14).
Seat belt warning lamp bulb. Withdraw the centre console. Remove the push-fit
bulb holder (16) from the lamp and remove the bayonet fixing type bulb
(15).
Cigar lighter illumination bulb. Withdraw the centre console. Squeeze the
sides
of the bulb .hood (17) and remove the hood. Remove the bulb holder (18)
from
the hood clip and remove the bayonet fixing type bulb (19).
f:G
15 16
~
Hide quick links:
Advertisement
Table of Contents
