Troubleshooting Tips; Trouble Shooting - RCA RACP1206 Owner's Manual

TROUBLESHOOTING TIPS

TROUBLE SHOOTING

TROUBLES
POSSIBLE CAUSES
1. Unit does not
- P1 appears in the display window
Start when
Pressing on/off
- Room temperature is lower than
Button
the set temperature.(Cooling mode)
- The windows or doors in the room
are not closed.
- There are heat sources inside the
2. Not cool enough
room.
- Exhaust air duct is not connected or
blocked.
- Temperature setting is too high.
- Air filter is blocked by dust.
4. Noisy or vibration
- The ground is not level or not flat
enough.
5. Gurgling sound - The sound comes from the flowing
of the refrigerant inside the
air-conditioner.
- The automatic over heat
6. Power shut off at protection function. When the
temperature at the air outlet
Heating mode
exceed 70 C/158 F,th e de vice
will st op.
The rating data indicated on the energy label is based
on the testing condition of installing the un-extended
air exhaust duct without adaptor A & B (The duct and
the adaptor A & B are listed in the accessories chart
of the Instruction Manual).
SUGGEST REMEDIES
Drain the water in the bottom tray.
Reset the temperature.
Make sure all the windows and
doors are closed.
Remove the heat sources if possible.
Connect the duct and make
sure it can function properly.
Decrease the set temperature.
Clean the air filter.
Place the unit on a flat, level
ground if possible.
It is normal.
Switch on again after the unit
has cool down.
O O
NOTE
15