Names Of Parts; Air Conditioner Features; Electronic Control Operating Instructions - RCA RACP1206 Owner's Manual

IDENTIFICATION OF PARTS

NAMES OF PARTS

1
2
4
3
Fig.1
Model A
1
2
3
5
4
Model B
Fig.2
6
9
10
7
11
8
12
13
Fig.3
Front
Operation Panel
1
Horizontal Louver Blade
2
(swing automatically)
3
Caster
4
Carrying Handle
(both sides)
Operation Panel
1
Horizontal Louver Blade
2
(manually)
Remote signal receptor
3
4 Caster
5
Carrying Handle
(both sides)
Rear
Upper Air Filter
6
(Behind the grille)
Air Outlet
7
Power cord outlet
8
Air intake
9
Drain Outlet
10
Air intake
11
Lower Air Filter
12
(Behind the grille)
13
Bottom tray drain outlet
5

ELECTRONIC CONTROL OPERATING INSTRUCTIONS

Before you begin, thoroughly familiarize yourself with the control panel and remote controller
and all its functions, then follow the symbol for the functions you desire.
The unit can be controlled by the unit control panel alone or with the remote controller .
NOTE: This manual does not include Remote Controller Operations, see the <<Remote
Controller Instruction>> packed with the unit for details.
OPERATION PANEL OF THE AIR CONDITIONER
(The model has no
auto swing feature
6
withou t this button)
9
SWING
AUTO COOL
HEAT DRY
MODE
FAN
2
1
Fig.4
MODE select button
1
Selects the appropriate operating mode.
Each time you press the button, a mode
is selected in a sequence that goes from
AUTO, COOL, DRY, FAN and HEAT(cooling
only models without). The mode indicator light
illuminates under the different mode settings
Fig.4.
2 TIMER button
Used to initiate the AUTO ON start time and
AUTO OFF stop time program, in conjuction
with the & buttons.
3
POWER button
Power switch on/off.
SLEEP button
4
Used to initiate the SLEEP operation.
5 FAN button
Control the fan speed. Press to select the fan
speed in four steps-LOW, MED, HI and AUTO.
The fan speed indicator light illuminates under
different fan settings except AUTO speed. When
select AUTO fan speed, all the fan indicator lights
turn dark.

AIR CONDITIONER FEATURES

Remote signal receptor
(Some models have the
signal receptor on the
8
7
6
front panel , Fig.2)
ION
C
F
TIMER ON
SLEEP
FAN
TIMER OFF
3 4 5
6 UP( ) and DOWN( ) button
Used to adjust (increasing/decreasing)
temperature settings(1 C/2 F increments)
in a range of 17 C(62 F) to 30 C(88 F) or
the TIMER setting in a range of 0~24hrs..
NOTE: The control is capable of displaying
temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other, press
and hold the Up and Down buttons at the same
time, for 3 seconds.
7 LED Display
Shows the set temperature in
" F" and the Auto-timer settings. O
While on DRY and FAN modes, it shows
the room temperature.
Error codes and protection code:
E1- Room temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
E2- Evaporator temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
E4- Display panel communication error-
Unplug the unit and plug it back in.
If error repeats, call for service.
P1- Bottom tray is full - Connect the
drain hose and drain the collected
water away. If error repeats, call
for service.
6
HI
MED
LOW
" O " or
C