Specifications - Makita 9207SPB Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Max. capacities
Rated speed (n)/No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
DOUBLE INSULATION
Wear safety glasses.
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2012/19/EU on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for polishing, smoothing before
painting, finishing surfaces, and removing rust and paint.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Model
Wool bonnet
Spindle thread
)
0
Overall length
Net weight
Safety class
with household
equipment
environmentally compatible
END202-7
Noise
The typical
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
waste
determined according to EN60745:
Work mode : polishing
Vibration emission (a
and its
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENE051-1
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
ENF002-2
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
2
9207SPB
180 mm
M14
-1
4,100 min
455 mm
3.4 kg
/II
A-weighted noise level
) : 86 dB(A)
pA
) : 97 dB(A)
WA
Wear ear protection
total value (tri-axial
) : 5.0 m/s
h,P
2
ENG905-1
determined
ENG900-1
vector sum)
2
ENG902-1