Cleaning The Paper Feed Roller - Canon Pixma MG2500 Series Online Manual

Cleaning the Paper Feed Roller

If the paper feed rollers are dirty or paper powder is attached to it, paper may not be fed
properly.
In this case, clean the paper feed rollers. Cleaning will wear out the paper feed rollers, so
perform this only when necessary.
You need to prepare: a sheet of A4 or Letter-sized plain paper
1. Make sure that the power is turned on and remove any paper from the
rear tray.
2. Clean the paper feed rollers without paper.
(1) Hold down the Stop button until the Alarm lamp flashes orange seven
times, then release it immediately.
The paper feed rollers will rotate as it is cleaned.
3. Clean the paper feed rollers with paper.
(1) Make sure that the paper feed rollers have stopped rotating, load a
sheet of A4 or Letter-sized plain paper in the rear tray.
(2) Pull out the paper output tray and the output tray extension.
(3) Hold down the Stop button until the Alarm lamp flashes orange seven
times, then release it immediately.
The machine starts cleaning. The cleaning will be complete when the paper is
ejected.
If the problem is not resolved after cleaning the paper feed rollers
off the power, unplug the power cord, then wipe the paper feed rollers (the center roller and
the right roller) located inside the rear tray with a moistened cotton swab or the like while
rotating them manually. Do not touch the rollers with your fingers. Rotate the rollers two or
more times.
94
(A) in the rear tray, turn