Table of Contents
Advertisement
Table 5 Installation, Commissioning, Confirmation Form (G83/1)
Site Details
Site address (inc. post code)
Telephone number
Customer supply number
Distribution network operator (DNO)
Contact Details
SSEG owner
Contact person
Contact telephone number
Serial number / version numbers of software (where
appropriate)
SSEG rating (A) and power factor (under normal
running conditions)
Maximum peak short circuit and fuel source
Location of prime mover and fuel source
Location of SSEG unit
Location of multi pole isolator
Installer Details
Installer
Accreditation / Qualification
Address (inc post code)
Contact person
Telephone number
Fax number
E-mail address
Information to be Enclosed
Final copy of system schematic
SSEG Test Report (Appendix 4) or web address if appropriate
Computer print out (where possible or other schedule of protection settings
Electricity meter make and model
Declaration – to be completed by Installer
The SSEG installation complies with the relevant sections of Engineering Recommendation
G83/1.
Protection settings have been set to comply with Engineering Recommendation G83 or EN
50438
The protection settings are protected from alteration except by prior written agreement
between the DNO and the Customer or his agent.
Safety
labels
have
been
fitted
in
accordance
with
section
6.1
of
Engineering
Recommendations G83/1.
The SSEG installation complies with the relevant sections of BS 7671 and an installation test
certificate is attached.
Comments (continue of separate sheet if necessary).
Name:
Signature:
Date:
51 of 88
Navien stirling engine m-CHP installation manual
Page No:
Advertisement
Table of Contents
