Oster FPSTJE316R Instruction Manual page 21

BLEND USING THE TO-GO-CUP AND BLENDING
BASE (MODEL FPSTJE316P ONLY)
NOTE: If unit is assembled as a juice extractor, please follow the instructions in the
section "AFTER USING YOUR APPLIANCE".
1. Place the To-Go-Cup without the lid on a flat dry surface with the open-end facing
up, fill it with all the desired ingredients place the blade assembly upside down
(blade facing down) on top of the To-Go-Cup (Figure 1). Turn the blade assembly
clockwise to tighten.
2. Flip the blending base upside down and place on top of the To-Go-Cup ensuring
the tabs on the To-Go-Cup are aligned with the slots on the blending base
(Figure 2).
3. Turn the blender assembly counterclockwise to the lock position until it stops
(Figure 3).
Fig. 1
4. Turn over the blender assembly and place on motor base (Figure 4) ensuring to
align the tab on the blending base with the motor base (Figure 5).
Fig. 4
Fig. 2
Fig. 5
En glis h-7
Fig. 3