Vcr Setup - Sanyo MPX-CD16P Instruction Manual

VCR SETUP

Setting
1
1
Press the MENU button, then press the O button to select "5. VCR SET".
2
Press the MENU button.
3
Press the + (or –) button to select the desired setting for "VCR MODE", then press the O button.
Following the same procedure, select the desired settings for "VCR OUT", "VCR REC SPEED", "VCR ALARM
REC SPEED", "POSITION". (For more information on each setting, please refer to "VCR Settings" below.)
4
Press the MENU button, then press the O button to select "7. ENTER" and press the MENU button again.
VCR Settings
VCR MODE
Set the mode according to the type of VCR connected to the unit.
SP: When using a timelapse VCR.
LP: When using a real time VCR.
VCR OUT
Set the "VCR OUT" 1 or 3 described below in order to get the
clear picture when the real time VCR is connected.
When "SP" is selected for the "VCR MODE", the "VCR OUT"
setting is then fixed to "1".
When "LP" is selected for the "VCR MODE", the "VCR OUT"
setting can be switched between "1" and "3".
1: The unit will switch the input to the next camera after one
(1) image is output.
3: The unit will switch the input to the next camera after three
(3) images are output.
VCR REC SPEED
Set the duration according to the VCR recording speed.
SP: 3H, 12H, 24H, 48H, 72H, 96H, 120H, 168H, 240H, 360H,
480H, 720H, 960H
LP: 6H, 18H, 30H, 48H, 72H, 96H, 120H, 168H, 240H, 360H,
480H, 720H, 960H
The duration indicated is for when using an E-180 tape.
Real time VCRs use E-240 tapes, therefore the durations will be
as indicated by the examples below.
Set duration (based on a E-180 tape)
Real time VCR recording duration
(based on a E-240 tape)
2
6H 18H 30H
8H 24H 40H
3
VCR ALARM REC SPEED
Set the duration according to the VCR alarm recording
duration.
SP: 3H, 12H, 24H, NC, F3H
LP: 6H, 18H, NC, F6H
NC: During alarm recording on the timelapse/real time
VCR, the recording speed will remain the same.
When using the SW signal
Some Timelapse/real time VCRs do not output a SW signal in
3H mode, therefore in order to keep the same recording speed
as the connected VCR, set this unit as follows.
•
Set "VCR REC SPEED" to 3H.
•
When using an alarm recording of 3H (or 6H in LP mode),
set "VCR ALARM REC SPEED" to "F3H" (or to "F6H" in LP
mode).
•
If using a timelapse/real time VCR with a switching output
(SW OUT) function, then set "FIELD" to "01", "TIMING" to
"FIELD", "3H" to "Y" (Yes).
POSITION
↑: Will switch when the signal at the SW IN terminal goes to High.
↓: Will switch when the signal at the SW IN terminal goes to Low.
12
Menu 5
4
English