Troy-Bilt 204 Operator's Manual page 7

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
4. a. Remove the two flange nuts, hex bolts and saddle
washers which secure the right side of the upper
handle to the right side of the lower handle. See
Figure 4.
b. Remove the three hex nuts and bell washers from
the weld studs beside the opening on the right side
of the chipper-shredder vacuum. See Figure 4.
5. a. Place the chipper chute over the weld studs keep-
ing the slotted side towards the bottom. Loosely
secure with the three hex nuts and bell washers
that were removed earlier. Do not fully tighten the
hex nuts at this point in the assembly. See Figure 5.
b. Align the support bracket with the holes in the right
side of the upper and lower handles where the hex
bolts were just removed. Push up slightly on the
chipper chute in order to better align the holes in
the support bracket with the holes in the handles.
c. Replace the hex bolts, saddle washers and flange
nuts to affix the support bracket to the handle
assemblies. See Figure 5.
d. Follow by tightening all hardware securely first on
the chipper chute, then on the support bracket, and
finally on the handle.
Attaching The Bag
6. a. Place bag under the upper handle assembly and
slip the front opening on the bag over the discharge
chute, making certain it is over the rim on the
discharge chute. Follow direction of the arrows in
Figure 6.
b. Place the four straps on top of the bag over the
upper handle, hooking them on the studs to secure
in place. See Figure 6.
7. Squeeze the clamp on the drawstring and pull the
drawstring tight. Release the clamp. See Figure 7.
Figure 7
�� �� � �
7
www.mymowerparts.com www.mymowerparts.com
�
�
Figure 4
� � �
Figure 5
�
�
Figure 6
3
Setting
Up Your
Chipper
Shredder
Vacuum