Setting Up Your Chipper Shredder Vacuum - Troy-Bilt 204 Operator's Manual

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
3
Setting
Up Your
Chipper
Shredder
Vacuum
IMPORTANT
This unit is shipped
without gasoline or
oil in the engine. Be
certain to service
engine with gasoline
and oil as instructed
in the separate engine
manual before operat-
ing your machine.
NOTE: All references
in this manual to the
left or right side of
the chipper shredder
vacuum is from the
operating position only.
Exceptions, if any, will
be specified.
NOTE: The metal tab
on the nozzle must
depress the safety
switch button attached
to the front of the chip-
per shredder vacuum
or the engine will not
start.
������
���
�������
����
������
�������
Figure 1
�
�
����� ���
Figure 2
Figure 3
www.mymowerparts.com www.mymowerparts.com
IMPORTANT: This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your machine.
Loose Parts In Carton
�������
1. Following is the list of loose parts shipped with your
����� equipment. Compare the parts with the illustration in
Figure 1 to identify these items.
a. Nozzle
b. Bag
c. Chipper Chute
d. Engine Oil (May be located in bag)
e. Safety Glasses
f. Tamper Plug (If Equipped)
NOTE: All references in this manual to the left or right
������ �� ���
side of the yard vacuum is from the operating position
only. Exceptions, if any, will be specified.
��� ��������
Attaching The Nozzle
2. a. Remove three wing nuts from the front of the
chipper shredder vacuum. See Figure 2.
b. Place nozzle in position over three studs on unit.
c. Secure with wing nuts just removed. See Figure 2.
NOTE: The metal tab on the nozzle must depress the
safety switch button attached to the front of the chipper
shredder vacuum or engine will not start. See Figure 2.
Attaching The Chipper Chute
3. Loosen, but do not remove, the two hex bolts, flat
washers, and flange nuts which are secured to the
�
support bracket. See Figure 3.
6