Troy-Bilt 204 Operator's Manual page 13

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
14. Remove the inner housing and mounting adapter by
removing the five hex bolts and two hex nuts. See
Figure 16.
15.Insert new belt between the frame and the transmis-
sion pulley. See Figure 17. (You may have to slightly
pry the frame away from the pulley with a screwdriver
for this.)
16.Press down on the belt guard spring by the idler
pulley, and release the spring from the slot on the idler
bracket.
17. Place the belt on the idler pulley and place belt guard
spring back into the slot on the idler bracket. See
Figure 17.
18.Place the mounting adapter against the engine and
make sure the hole in the mounting adapter is facing
up.
19. Place the inner housing against the mounting adapter
and the frame. Secure with five hex bolts and two hex
nuts previously removed. Refer to Figure 16.
20.Slide the impeller assembly onto the crankshaft and
place a screwdriver under the belt. Turn the impeller
assembly counterclockwise to place the belt into the
slot on the impeller. Make sure the belt is routed inside
all belt guards.
21. Secure impeller assembly to crankshaft using hex
bolt, lock washer, and flat washer previously removed.
Torque bolt between 550-700 in. lb.
22.Place the housing blades against the inner housing.
Refer to Figure 15.
23.Place the outer housing against the inner housing.
See Figure 18. Insert two screwdrivers into the holes
to hold the blades in place while attaching the outer
housing.
24.Secure with the 14 self-tapping screws, previously
removed. Insert all screws first before tightening.
25.Reassemble the flail screen, discharge chute, nozzle
and the bag. (For reassembly, follow instructions on
previous page in reverse order.)
Storing Your Yard Vacuum
1. Clean the equipment thoroughly.
2. Wipe equipment with an oiled rag to prevent rust.
3. Refer to engine manual for correct engine storage
instructions.
4. Store unit in a clean, dry area. Do not store next to
corrosive materials such as fertilizer.
WARNING: Never store the machine or
fuel container indoors where there is
an open flame, spark, or pilot light such
as on a water heater, furnace, clothes
dryer, or other gas appliance.
���� �����
������
�����
������������ ������
������ ������������
13
www.mymowerparts.com www.mymowerparts.com
Figure 16
��������
�������
�����
�������
�����
Figure 17
Figure 18
5
Maintaining
Your
Chipper
Shredder
Vacuum
WARNING
Never store the machine
or fuel container indoors
where there is an open
flame, spark, or pilot
light such as on a water
heater, furnace, clothes
dryer, or other gas
appliance.