Installing Latch Child Seats; Attaching Upper Tether Straps - Tesla S Owner's Manual

Installing LATCH Child Seats

Lower LATCH anchor positions are provided
in the second-row outboard seating positions
and are located between the seat's back rest
and rear cushion. The exact location of each
anchor is identified by a child safety seat
identification button, illustrated below. The
button is located on the seat back, directly
above its associated anchor.
Install LATCH seats in the outboard seating
positions only. Use only a seat belt retained
seat in the center position.
To install a LATCH retained child safety seat,
slide the safety seat latches onto the anchor
bars until they click into place. Carefully read
and follow the instructions provided by the
child safety seat manufacturer.
Once installed, test the security of the
installation before seating a child. Attempt to
twist the child safety seat from side to side
and try to pull it away from the seat, then
check that the anchors are still securely in
place.
Seating and Safety Restraints
Child Safety Seats

Attaching Upper Tether Straps

If an upper tether strap is provided, attach its
hook to the anchor point located on the back
of the rear seats. Always position single-strap
tethers so that it runs over the center of the
Model S head support. Tighten dual-strap
tethers to run on each side of the head
support. Tighten according to the child safety
seat manufacturer's instructions.
Note: To prevent single-strap tethers from
moving from side to side, the top of the head
support deforms.
25