Panasonic Viera TX-P42VT30E Operating Instructions Manual page 17

■
Battery status shown by indicator lamp
Power / indicator lamp status
Lights for 2 seconds when turned on
Flashes 5 times when turned on
Flashes once every 2 seconds when in use
Lights continuously when off
Lamp off
Attaching Ferrite Core
Be sure to attach the provided ferrite core to the charging cable to reduce interference or electrical noise.
1
Attach the ferrite core as close to USB connector of
the charging cable as shown.
USB connector
Charging the 3D Eyewear
Preparations
•
Set [USB Charge in Standby] in the Setup menu to [On].
•
Switch off the 3D Eyewear.
1
Turn the TV to Standby mode with the remote control.
2
Connect as shown in the diagram.
•
The indicator lamp lights red, and charging starts.
•
When the indicator lamp turns off, charging is completed. (Approximately 2 hours required)
3
After charging is completed, remove the charging cable.
Note
•
Do not turn the TV Off with Mains power On / Off switch during charging.
Storing and cleaning the 3D Eyewear
•
Use the supplied 3D Eyewear case to store the 3D Eyewear.
•
Avoid storing the 3D Eyewear in hot or highly humid locations.
•
Use a clean, soft and dry cloth to wipe the 3D Eyewear. Otherwise, dirt or dust may scratch the eyewear.
•
Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off.
•
Do not submerge the 3D Eyewear in liquid such as water when cleaning.
•
During the long period of disuse, full charge the 3D Eyewear once every 6 months to keep the battery performance.
•
As the liquid crystal shutters (lens) are fragile and easily broken, be very careful when cleaning them.
2
Mini USB connector
Mini USB connector
Battery status
Sufficient battery level
Low battery level
Operating normally
Charging
Power off
Close the ferrite core until it clicks.
USB connector
USB connector
17